Inflating & deflating the Stand-Up Paddleboard
INFLATION
The SUP is equipped with a new-generation valve to guarantee even more security.
To inflate your SUP, open the cover and connect the pump (“IN” mode).
Inflate to 17 psi for best results.
Disconnect the pump and close the exterior cover
DEFLATING
Turn the cover a quarter clockwise (“OUT” mode).
Roll starting from the side opposite to the valve to remove all the air to completely fold
Close the cap
Technical dimensions
INFLATED SUP:
Length: 14' (427 cm)
Width: 27" (69 cm)
Thickness: 6" (15 cm)
Volume: 310 litres
Weight: 12 kg (+/- 10%)
important: the dimensions can vary slightly depending on the inflated pressure.
BAG CONTAINING THE FOLDED SUP:
Height: 80 cm
Width: 45 cm
Thickness:30 cm
Weight in use
This SUP board was designed and optimised for intermediate paddlers between 80 kg and 100 kg for good speed/stability balance.
However, stability is a notion relative to one’s level and the conditions (flat water, sea, river, etc.). The weight is thus illustrative. Don't hesitate to ask to try out the product.
For one person. the maximum recommended weight is 110 kg.
Repair
In the event of a hole in the structure, it is possible to repair the SUP with the cuttable repair patches and a high-pressure resistant MEK glue.
We have a stand-up paddleboard repair kit, reference 8512384.
Fin
Plastic fin available through the After Sales Service and online in the event of breakage or loss (red: 8609360).
You can also upgrade your product with a SUP carbon racing fin (ref 8545438)
ACCESSORIES
Included with the board:
- a carry bag
- a 10’ coiled leash
- 1 US box fin
- 2 repair patches
- 1 instructions for use
The paddle and pump are not included, we recommend you visit our website to properly equip yourself