Weight
Total weight 1.3 kg
Separable parts to help transportation.
Flysheet 365 g
Bedroom 420 g
Pole kit 290 g
Pegs (10 pieces) 100 g
Bags 45 g + 12 g
Guy ropes (4 pieces) 18 g
Repair kit (ferrule) 20 g
To protect your product and increase your protection from the sun and bad weather, you can complement your MT900 1P tent with the groundsheet with reference: 8545723 g).
The weight, volumes & sizes may vary slightly owing to production tolerances.
Size and living space
Bedroom length 210 cm
Bedroom width 60 cm to the head, 70 cm to the pelvis and 50 cm to the feet.
Bedroom height 95 cm
Total height 110 cm
Side porch around 70 cm wide and protected by a built-in sheet which shelters your equipment from the sun and bad weather. This provides storage space for 1 backpack up to about 70 litres.
3 pockets (1 head and 2 top) to keep and organise your belongings.
1 hook & loop for ropes
Architecture, tent poles and tent pegs
Lightweight, shock and frost resistant aluminium pole: 7001 T6 Yunan SD70PF Ø 8.3 mm aluminium.
Optimised square tent pegs: “anvil” head, oversized main part, extremely resistant and lightweight (7075 T6 aluminium). Non-anodised for a lower environmental impact.
Simple Y-shaped dome: the main pole splits into 3 feet giving a semi-freestanding structure. Top pole provides volume and therefore capacity.
Pitching/striking
Separate flysheet and bedroom. Traditional pitching method: bedroom on the ground and clipped to the poles. Cover the whole tent with the flysheet. Adjust the tautness.
If needed, the bedroom can be dismantled from inside.
Intuitive pitching thanks to colour coding on the pole, bedroom and flysheet.
When it rains, to pitch the flysheet first, you will need the compatible groundsheet (ref 8797781).
Waterproofing
Forclaz tents are laboratory-tested: pitched tent, 200 litres/sqm/hour (3 hours, equivalent to a tropical storm). They are also tested in the field by a sample user group.
20 denier polyester (PES) flysheet and 40D polyamide (PA) groundsheet have a polyurethane coating (inside) and silicone (exterior).
Seams taped with heat-sealed strips.
Multi-component bedroom combining breathability, wind protection and prevents condensation
Wind resistance
We test all our tents in a wind tunnel on a turntable where we can expose each side of the tent to the wind.
To test its wind resistance, the tent must be properly pitched, taut but not stretched, with all the guy ropes in position around the tent. It should remain habitable at wind speeds of 60km/h, measured near ground level.
Our tents are certified by the CSTB independent laboratory in Nantes.
Ventilation and condensation prevention
Bedroom with mosquito screen for ventilation and water-repellent fabric to protect from condensation and draughts. There are 2 large top ventilation areas that you can close using a Velcro strip.
To reduce condensation inside your tent, it must be properly pitched, with the fabric kept taut without being over-stretched. Two-way zips on the door to keep it open. The use of ventilation and good air circulation limits humidity inside your tent
Seasons
3-season tent: your tent will protect you from the harsh weather conditions you can encounter in the spring, summer or autumn. It will withstand light snowfall but is not designed to withstand heavy loads that would weigh on the structure.
In case of snow, remember to shake your tent regularly in order to bring down any snow that has accumulated to avoid putting too much weight on the structure of your tent.
Environmental approach
The poles are coloured using an innovative anodising method which eliminates the use of nitric and phosphoric acids.
Non-anodised tent pegs:
The pegs are not coloured or anodised (no acid is used). They may have a rough or used appearance but still have all their technical features.
These actions help to reduce the environmental impact of your product.
Repairs and After-sales service
As designers we are concerned about the durability of our products, which is why all our tents are designed to be repairable.
You will find spare parts (poles, chamber, etc.) on the shelves or in the workshop of your Decathlon shop, on our website, or contact support.
In case of problems, don't hesitate to have your tent checked in your Decathlon shop.
Repair kit (ferrule, patch): 20 g
Durability
Your tent is designed for itinerant bivouacking, it is therefore not designed for static use in the sun.
We recommend that you avoid leaving it in the sun as the ultra-light fabrics can be sensitive to UV light, that damages them.
Warranty
5 years.
All our tents are repairable. Parts and information in store or on our website
